Woodcore CWC Panel System

The CWC panel was constructed with uniform load performance in mind. The panel forms a rigid platform supporting high deflection loadings. This panel has been widely used in the international market as the alternative to the cementitious compound panel for comms/ data/ computer room applications. A unique feature of the CWC wood core panel is that load ratings are core reliant, meaning that the wood core substrate is responsible for carrying the loads placed on the floor. Unlike the SC and TC panels where a combination of steel plate and its core structure carries the loads, the CWC is the only panel where the core has a specific load bearing responsibility.

Panel Size                       Standard Panel
                                         600 x 600 x 35mm

                                         Finishing Panel
                                         600 x 300 x 35mm

Exterior                            Face: HPL standard finish
                                         Bottom: Galvanized steel sheet

Infill                                 Moisture resistant structural timber core

Panel Construction        The ASP CWC wood core panel is constructed from a high density moisture resistant

                                         structural timber core infill which is laminated in between the top HPL surface and the

                                         bottom steel sheet. The steel sheet has been treated with a corrosion resistant 

                                         phosphate primimg coat and then baked with an epoxy powder coat. The panel is

                                         then edged with recycled ABS plastic to seal the exposed substrate.

Standard Finishes         1. Factory applied High Pressure Laminate (HPL)

Panel Systems               1. HPL Wood Core System: CWC HPL System

HPL
1.6mm High pressure laminate finish applied to panel in ASP standard finish. Custom and specialised HPL colours available on request. The panel is edged with an ABS plastic trim to protect the woodcore infill.

Gravity Fixed Panels
Panels are gravity fixed to the pedestal head. Location of the panel is achieved using the gasket and its unique locating tabs.

Finishing Panels
Full bearing 600 x 300mm panels designed to minimise small off cuts around columns and finishing off to the perimeter.
The 600 x 300 panel may also be used when there is a necessity for a 300mm x 600mm air grille.

FFH Combinations
180-1200mm FFH S8 and S8 UK Combination
1200mm + FFH S11 Combination

Field/ Perimeter Pedestal:
S7, S7 UK, S11
The pedestal head remains the same for the entire system, where only minor changes are made to the pedestal tubes to suit the desired FFH.

Stringer: SC-S600
The stringer design is the same throughout the range. Predrilled holes at the end of each side allow the stringer to be screw fixed onto the pedestal head forming a rigid grid system. The top of the stringer comprises of 3mm sponge rubber foam providing a buffer between the stringer and the panel.