Timber Core Rigid Grid System
Selection Guide » Timber Core Rigid Grid System
This system, as the name suggests, has a permanently fixed rigid grid understructure made up from the pedestals and stringers. The stringers are screw fixed onto the pedestal heads forming a perfect 600 x 600mm square grid.
This system is recommended for applications such as:
- Where there will be constant rolling activity on the floor: i.e. banks
- General high load and traffic area: i.e. Corridors and lobbies
Gravity Fixed Panels:
Panels are gravity fixed to the understructure with stringers providing location and extra strength.
Corner Screw Panel:
Screw hole, in each corner, allows the panels to be individually screw fixed providing greater rigidity. This system can be gravity fixed or can be gravity AND screw fixed.
Finishing Panels
Full bearing 600 x 300mm and 600 x 800mm panels designed to minimize small off cuts, around columns and finishing off to the perimeter. The 600 x 300 panel may also be used when there is a necessity for a 300mm x 600mm air grille.
FFH Combinations
180-1200mm FFH S8 and S8 UK Combination
1200mm + FFH S11 Combination
Field/ Perimeter Pedestal:
S8, S8 UK, S11
The pedestal head remains the same for the entire system, where only minor changes are made to the pedestal tubes to suit the desired FFH.
Stringer: SC-600
The stringer design is the same throughout the range. Predrilled holes at the end of each side allow the stringer to be screw fixed onto the pedestal head forming a rigid grid system. The top of the stringer comprises of 3mm sponge rubber foam providing a buffer between the stringer and the panel.
